[SIPHEC home]

TI-MSP430F169-TB   MSP430F169 TinyBoard

Category: Development Board, TI MSP430 Microcontroller, TI MSP430,
Keywords: Microcontroller, Development Board, Prototype Board, Low Power 16bit Microcontroller, Texas Instruments TI MSP430F

MSP430 Development Board / Prototype Board, MSP430 Board

• full motherboard for MSP430F169
• super thin board
• with MSP430F148  (other devices possible)
• all pins are all available on headers
• high computing power 
• easy to use: just connect to power supply (+1.8 to +3.6V) and program device
• runs with internal oscillator
• prepared for equipment with 3 different crystals X1, X2, X3
• JTAG header
• board fits in 2.54mm pitch prototype PCB
   
• device specific data (MSP430F169)
  • 8 MHz clock frequency
  • 60 KB Flash
  • 2 KB RAM
  • 48 GPIO
  • 12-bit SAR ADC
  • other integrated peripherals
    2x 12bit DAC, analog comparator, DMA, hardware multiplier, SVS
  • interface
    2x hardware SPI or UART, timer UART, hardware I2C
  • timers
    1x watchdog/interval, 1x 16-bit (3CCR), 1x 16-bit (7CCR)  
    
     
• programming: 
  • free kickstart software at TI's web page: www.ti.com/sc/msp430
  • free MSP430 GNU C-Compiler mspgcc for Linux and Windows
    see MSP430 HOWTO

MSP430F chip specification

• high computing power
• low supply-voltage range, 1.8 V to 3.6 V
• ultralow-power consumption
  – active mode: 330 µA at 1 MHz, 2.2 V
  – standby mode: 1.1 µA
  – off mode (RAM retention): 0.2 µA
• five power-saving modes
• wake-up from standby mode in less than 6 µs
• 16-Bit RISC architecture, 125-ns instruction cycle time
• three-channel internal DMA
• 12-Bit A/D converter with internal reference, sample-and-hold and autoscan feature
• dual 12-Bit D/A converters with synchronization
• 16-Bit timer_A with three capture/compare registers
• 16-Bit timer_B with three or seven capture/compare-with-shadow registers
• on-chip comparator
• serial communication interface (USART0), functions as asynchronous UART or synchronous SPI or I²C™ interface
• serial communication interface (USART1), functions as asynchronous UART or synchronous SPI interface
• supply voltage supervisor/monitor with programmable level detection
• brownout detector
• bootstrap loader
• serial onboard programming, no external programming voltage needed, programmable code protection by security fuse

• MSP430F device specification (datasheet, user quide)

  TI MSP430x15x, MSP430x16x, MSP430x161x datasheet (pdf)

  TI MSP430x1xx Family User's Guide (pdf)

• programming: 
  • free kickstart software at TI's web page: www.ti.com/sc/msp430
  • free MSP430 GNU C-Compiler mspgcc for Linux and Windows
    see MSP430 HOWTO

[SIPHEC home]